ĥ Cross section of transom showing EP-80R TH installed. Make sure the nut has been removed from the. Using a high quality, marine-g rade above- or below-waterline seal- ant/adhesive compound, apply a 1/8" (3 mm ) bead of sealant around the lip of the EP-80R TH housing. This will establish a good surface for the adhesive. Ĥ Afterwards, clean the area around th e hole with detergent or alcohol. Recommended Tools and supp lies Recommended tools for this job include: drill, 1/8" (3 mm) drill bit for pilot hole, 1-1/16 (27 mm) hole saw with a blade type appropriate for the com- position of your transom. Includes a 2-foot extension cable, T connector and two 120-ohm terminators. ģ LowranceNET Node Kit for a NMEA 2000 network. For free software upgrades or additional information on the LowranceNet NMEA 2000 ® network system, visit our web site, The EP-80R TH consists of the temp sensor module, a red cable connec- tor and the smart module, which converts analog. Ģ Some sonar or GPS units may require a software upgrade to display NMEA 2000 data correctly. It also provides instructions on how to configure your temp sensor with Lowrance digi- tal gauges (LMF-200 & LMF-400). 988-0154-442 EP-80R TH Electronic Thru-Hull Temp Sensor Installation and Configuration Instructions This document shows how to install an EP-80R TH thru-hull temp sen- sor and how to connect it to a NMEA 2000 ® network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |